Polycom - NTP Server Time/Date Config

Polycom - NTP Server Time/Date Config
 

 

The date and time one the phone can be set by synchronizing it with an NTP server (Network Time Protocol server). This can be done by logging into your Polycom phone through a web browser. Log into the IP address of the phone:
http://192.168.0.102 for example.

  1. Choose the "General" tab
  2. Default username: "Polycom"
  3. Default password: "456"
  • Choose "Time"
  • SNTP Server: pool.ntp.org
  • GMT Offset: -5 for EST
    • -6 for CST
    • -7 for MST
    • -8 for PST
  • SNTP Resync Period: 86400

Choose "Submit" to submit your settings and reboot the phone.

There is one potential issue with Polycom phones and the time settings: The DHCP server will ALWAYS over-ride the time settings from the WWW interface. Therefore, if the time is not correctly set on your DHCP server (the server/router - where the Polycom phone obtains it's internal IP address) then the time will be incorrect on the phone itself.

If the above settings do not correct reset the time settings for the phone, then the phone is obtaining it's time settings from the DHCP server. You must then, check the DHCP server for the correct time.

  • 0 Users Found This Useful
Was this answer helpful?

Related Articles

Basic Forwarding

Basic Forwarding   To use Basic Forwarding please follow these steps... 1....

Call Forwarding from device

Call Forwarding from device   To enable call forwarding from your device...

Call Parking

Call Parking   Call parking allows users to put a conversation on hold and...

Configuring Paging/Intercom

Configuring Paging/Intercom   To enable Paging/Intercom you have to do the...

Disable Voicemail Trash Folder

Disable Voicemail Trash Folder   The Trash folder option is on by default as a...