Polycom - NTP Server Time/Date Config

Polycom - NTP Server Time/Date Config
 

 

The date and time one the phone can be set by synchronizing it with an NTP server (Network Time Protocol server). This can be done by logging into your Polycom phone through a web browser. Log into the IP address of the phone:
http://192.168.0.102 for example.

  1. Choose the "General" tab
  2. Default username: "Polycom"
  3. Default password: "456"
  • Choose "Time"
  • SNTP Server: pool.ntp.org
  • GMT Offset: -5 for EST
    • -6 for CST
    • -7 for MST
    • -8 for PST
  • SNTP Resync Period: 86400

Choose "Submit" to submit your settings and reboot the phone.

There is one potential issue with Polycom phones and the time settings: The DHCP server will ALWAYS over-ride the time settings from the WWW interface. Therefore, if the time is not correctly set on your DHCP server (the server/router - where the Polycom phone obtains it's internal IP address) then the time will be incorrect on the phone itself.

If the above settings do not correct reset the time settings for the phone, then the phone is obtaining it's time settings from the DHCP server. You must then, check the DHCP server for the correct time.

  • 0 Users Found This Useful
Was this answer helpful?

Related Articles

Upgrade Firmare Yealink Phones

Upgrade Firmare Yealink Phones   1. Go to yealink.com and click the Support...

Configuring Paging/Intercom

Configuring Paging/Intercom   To enable Paging/Intercom you have to do the...

How to Disable the Typing Animation Feature in Office 2013

How to Disable the Typing Animation Feature in Office 2013   How to Disable...

How to reset Polycom phones to factory defaults

How to reset Polycom phones to factory defaults   For second-hand phones, it...

Resetting a Polycom IP450 to factory defaults

Resetting a Polycom IP450 to factory defaults   How-to Steps | Polycom...